Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boral Roofing: The Jacksonville Owner’s Guide
Boral roofing replacement in Jacksonville typically runs $8,000 to $20,000 for a full tear-off and re-roof, while targeted Boral tile repairs land between $600 and $2,500 depending on how many tiles failed and what’s happening underneath them. Most Jacksonville homeowners discover a Boral part has failed after a storm blows through and they find tile fragments in the yard, or a ceiling stain starts spreading in a corner bedroom. The failure usually traces back to a cracked tile, a failed underlayment seam, or a flashing point that gave up after years of Florida sun and sideways rain.
We’re an independent Jacksonville contractor that stocks and installs Boral-compatible roofing parts. We’re not a Boral company outlet and we don’t pretend to be. What we are is a crew that’s spent years matching Boral tile profiles to the right underlayment and flashing systems for this climate, and we write a price before we touch your roof. If you’ve got a failed Boral roof component, you want two things: the correct replacement part on the truck the first trip, and an installed price that doesn’t move. That’s what this page is for.
Key Takeaways
- Boral tile repair in Jacksonville: $600 $2,500 for spot work; full replacement: $8,000 $20,000
- Boral roof tile is concrete, not clay it handles Florida humidity but can crack from impact or underlayment movement
- The part that typically fails first is not the tile it’s the underlayment or the flashing beneath it
- We carry Boral-compatible tile profiles and underlayment materials on the truck for most Jacksonville jobs
- Every repair or replacement gets a written price before work starts and the 365-Day Done Right Promise after
Which Boral Models This Applies To
Boral’s roofing line splits into a few distinct families, and the part you need depends on which one is on your Jacksonville house. The most common Boral profiles we see across Jacksonville neighborhoods like Mandarin, Avondale, and San Marco are the flat and low-profile concrete tiles: Boral’s Slate, Shake, and Barrel lines, plus the older Boral Mission and Roman profiles still sitting on homes built in the 1990s and early 2000s. Each profile has a specific underlayment requirement, and here’s a compatibility gotcha most homeowners never hear: Boral concrete tile is heavier than most asphalt singles, and the roof deck under a tile roof needs to be rated for roughly 10 pounds per square foot dead load. A roof that was built for a shingle tear-off and re-roofed with tile without a structural check is a problem waiting to show itself in Jacksonville’s summer storms.
Start by looking at a tile you can reach safely from a ladder, not the roof itself. Flip a broken tile and check for a stamped code on the underside. Boral stamps their tiles with a profile code and a manufacturing date code, which makes matching easy when you have that. Take a photo of the underside and text it to us at (904) 337-5929 before we come out. As for OEM versus aftermarket: Boral’s own replacement tiles are the safest match because the color blends have shifted slightly over manufacturing years. A good-quality aftermarket tile can work, but the color match on a 15-year-old roof is never perfect. We’ll tell you plainly whether an OEM tile is worth the wait or whether an aftermarket equivalent will do the job without being obvious from the street.
Styles & brands we work with
Signs Your Boral Roofing Is Failing
Early warning signs show up before a full leak does. Here’s what we see on Boral roofs across Jacksonville, from the dry cracks up top to the water chasing down inside:
- Tile fragments in the yard or gutters after a storm. Concrete tile doesn’t flex. A branch or wind-driven object hits it and it cracks, typically along the nail line. One broken tile is not a crisis, but let it go and water gets underneath the tile field.
- Dark staining or visible sagging in the roof deck from inside the attic. This points to underlayment failure, not tile failure. The tile can look fine from the street while the waterproof layer beneath it has given up. We find this throughout Jacksonville, especially on roofs with original 20-year-old underlayment.
- Ceiling stains in a corner or along an exterior wall. Water travels. A small flashing failure at a valley or chimney can show up as a stain 10 feet away from the actual compromise. Don’t chase the stain; trace the leak.
- Loose or sliding tiles near hips and ridges. These are the highest-wind zones on any Jacksonville roof. The fasteners or the mortar at these points wear first, and once a tile shifts, it acts like a wind scoop that keeps lifting its neighbors.
- Granular sand-like grit piling in the gutter. Concrete tile erodes over time, especially the flat profiles. Some surface wear is normal; a lot of it in one spot means that tile has a structural crack and needs replacing.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Jacksonville, Boral tile repair pricing breaks down like this:
- Spot tile replacement (1-10 tiles): $600 $2,500 installed
- Flashing repair or valley rebuild: $800 $2,200 installed
- Underlayment section replacement with tile reset: $1,500 $4,000 installed
- Full Boral tile roof replacement: $8,000 $20,000 installed
What moves the number is access, roof pitch, and the condition of what’s under the tile. A two-story tile roof in Ortega with a 12/12 pitch costs more than a single-story ranch in Arlington. What doesn’t move is the price once we give it to you. Every Bradford Remodeling Co Jacksonville job gets a written, line-item quote before any work starts, and that price holds. The installed cost includes the tile or part, fasteners, underlayment matching, disposal of the failed material, and a clean site at closeout. Every completed roof repair carries the 365-Day Done Right Promise: if the fix fails within a year, we come back and correct it at no charge.
DIY or Call Us?
Here’s the honest split from a guy who’s been on Jacksonville roofs for years and learned the trade at Los Angeles Trade-Technical College before running crews across the Southeast. You can check your gutters, look for tile fragments, and take photos of a broken tile from a ladder. That’s safe and it helps us diagnose. What you should not do is walk a tile roof yourself. Boral concrete tile cracks under point pressure, and a cracked tile under your boot can put you through the roof deck on a 30-foot drop. Tile roofs in Florida also get dangerously slick with morning dew and moss. That’s not a scare tactic; it’s just physics.
We send background-checked, uniformed technicians who carry proper roof ladders, harnesses when the pitch warrants it, and the right parts for Boral profiles. If you spot tile fragments, call us at (904) 337-5929. We’ll tell you over the phone whether it sounds like a spot fix or a larger issue, and we’ll give you a written price before we set foot on the roof. Scope it right the first time the job goes a lot smoother when nobody’s surprised.
FAQs
Boral concrete tile roof systems are rated to last 50 years or more, but the underlayment beneath them in Jacksonville’s heat and humidity typically gives out at 20 to 25 years, which is why we replace underlayment more often than tile. Call (904) 337-5929 for an exact assessment of your roof’s remaining life estimates are free.
A hairline crack can sometimes be sealed, but a tile with a full crack or a missing corner should be replaced because Florida wind-driven rain will find that crack and get under it. We’ll tell you honestly whether repair is an option once we see the tile and its position on your roof.
Most spot tile replacements and flashing repairs take a half day to a full day when we have the profile matched; a full underlayment section with tile reset can run two to three days. For an exact schedule on your Jacksonville home, call (904) 337-5929.
We keep common Boral flat, shake, and barrel profile tiles plus matching underlayment materials on hand for Jacksonville jobs, and we maintain relationships with regional distributors for OEM Boral parts when the color match demands it. Call us with the profile code from the underside of a broken tile and we’ll tell you if we’ve got it on the truck.
Call (904) 337-5929 for a free estimate on your Boral roofing repair in Jacksonville. A live person answers around the clock, and you’ll get a written price before any work starts.
Written by Curtis Lane, Owner, Bradford Remodeling Co Jacksonville at Bradford Remodeling Co Jacksonville, serving Jacksonville and nearby areas.
