Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
IKO Kitchen Remodeling: The Jacksonville Owner’s Guide
If you have an IKO kitchen system that’s failing, you’re likely looking at a full remodel rather than a single-part swap. A complete IKO kitchen remodeling project in Jacksonville typically runs $14,000 to $45,000 installed, depending on cabinet count, countertop material, and whether we’re moving plumbing or electrical. Most homeowners discover the problem the hard way: a cabinet face delaminates, a drawer track seizes, or the countertop substrate swells from years of Florida humidity and starts pushing the surface up. Bradford Remodeling Co Jacksonville is an independent contractor, not affiliated with IKO, but we work with IKO-compatible systems every week and can match the right materials and labor to your kitchen’s current footprint.
Key Takeaways:
- Typical IKO kitchen remodel in Jacksonville: $14,000 – $45,000
- We document every scope in writing before work starts, under The Garrison Standard
- 365-Day Done Right Promise covers all completed work for a full year
- We stock or can source IKO-compatible cabinet components, hinges, slides, and hardware quickly
- Free estimates: call (904) 337-5929
Which IKO Models This Applies To
IKO’s kitchen line spans several series, and the compatibility gotcha most Jacksonville homeowners hit is assuming all IKO cabinet boxes use the same hinge boring pattern. They don’t. Older IKO units, especially those installed in the early 2000s, typically use a 35mm cup hinge with a 9.5mm depth, while newer lines may step up to a 40mm cup. Before ordering any replacement door or hinge set, measure the cup diameter and the edge-to-center distance on the existing door. If the numbers don’t match, a new door won’t hang right no matter how carefully you install it.
Another thing we see: IKO’s melamine-faced particleboard boxes are solid for what they are, but they were never designed for Northeast Florida’s humidity swings. Riverside, San Marco, Ortega, and the beaches all get different moisture loads, and kitchens without adequate range hood ventilation push that moisture straight into the cabinet boxes. We also work with KraftMaid, Cambria, and Silestone for clients who want to mix IKO-compatible bases with premium surface materials.
OEM IKO parts are fine when the failure is isolated, but for anything structural, a quality aftermarket equivalent often lasts longer because the substrate is thicker or the hardware is a known brand like Blum or Salice. We’ll tell you straight which path makes sense for your specific failure, and we’ll put that recommendation in writing.
Styles & brands we work with
Signs Your IKO Kitchen Remodeling Is Failing
- Cabinet doors no longer close flush or stay closed. The hinge cups have worn past their detent strength, or the screws have stripped out of the particleboard. Once the screw holes wallow out, re-tightening won’t hold. The fix is a repair plate or a door replacement, not another turn of the screwdriver.
- Drawer slides bind, squeal, or drop on one side. IKO’s original slides were typically a basic epoxy-coated runner. After years of Florida humidity and cooking grease, the roller bearings seize. Once a slide binds mid-travel, the drawer starts racking, which then damages the box joinery.
- Countertop surface is lifting or bubbling near the sink or dishwasher. This is substrate swelling, not a surface defect. Water has gotten under the laminate or veneer and soaked into the particleboard core. In Jacksonville, this is the most common IKO failure we see, and it’s usually terminal for that section of countertop.
- The toe-kick area is darkening, soft, or crumbling. Moisture from mopping or a slow plumbing drip has wicked up into the cabinet base. By the time you see it, the damage has usually climbed several inches into the box.
- Shelves are bowing under normal dish loads. IKO shelf spans over 36 inches should have been reinforced from the factory, but some early runs weren’t. If the shelf has a visible sag, it’s not going to recover. Replace the shelf and add a front stiffener while you’re at it.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
A full IKO-level kitchen remodel in Jacksonville runs $14,000 to $45,000 installed. Smaller kitchens, where we’re keeping the existing footprint and swapping cabinets, countertop, and backsplash, land in the $9,000 to $20,000 range. If you’re only replacing cabinets, plan for $4,000 to $13,000. Countertops alone run $2,000 to $6,500, and a new backsplash is $800 to $2,500. A kitchen island addition or rebuild runs $3,000 to $10,000.
What drives the spread: whether we’re moving plumbing or electrical, how many linear feet of countertop you need, whether the cabinet boxes themselves are salvageable, and what grade of hardware you choose. We write every line item down before we start. No “we’ll figure it out as we go.” You get a written price from Bradford Remodeling Co Jacksonville, and that price doesn’t move at the door. The Garrison Standard requires it. And when the job closes, you get a signed 365-Day Done Right Promise in your hand: if something fails within the year, we come back and correct it at no charge.
DIY or Call Us?
Some of this you can safely check yourself. Open every door. Run every drawer. Look under the sink with a flashlight. If you find a stripped hinge or a seized slide, that’s a straightforward replacement if you know the boring pattern and the slide length. If you find soft cabinets, swollen substrate, or water damage under the sink, that’s not a parts swap. That’s structural, and it needs a contractor who can cut out the damaged material, verify what’s behind it, and rebuild to current code.
The most common DIY mistake we see in Jacksonville is someone buying a 35mm hinge to replace a 40mm cup, or ordering a 22-inch slide to replace an 18-inch original, then forcing the drawer into place. By the time we’re called, the door is chipped, the drawer face is split, and the fix costs twice what the part alone would have. Scope it right the first time – the job goes a lot smoother when nobody’s surprised. If you’re unsure what you’re looking at, call us at (904) 337-5929. We’ll tell you over the phone whether it’s a parts order or a remodel.
FAQs
Expect 12 to 20 years from the cabinet boxes and hardware, and 8 to 15 years from the countertop before Florida humidity and daily use catch up, depending on ventilation and how well the original install was sealed. Call (904) 337-5929 for an assessment if your kitchen is in that window and showing wear.
Yes, if the cabinet boxes are solid and the damage is limited to doors, hinges, slides, or a single countertop section. If multiple boxes are swollen or the layout no longer works for you, a full remodel usually costs less long-term than repeated repairs. We’ll tell you which one you’re in.
A typical kitchen remodel runs 4 to 8 weeks depending on scope, cabinet lead times, and whether we’re changing plumbing or electrical locations. We’ll give you a written schedule with the written price before work starts.
We keep common hinge sets, slide lengths, shelf pins, and repair plates on our trucks, so many hardware replacements are a single-visit fix. For cabinet boxes or full kitchens, we order through our documented supplier network and give you the lead time in writing.
Ready to get a number? Call Curtis Lane and the team at Bradford Remodeling Co Jacksonville at (904) 337-5929 for a free estimate. We’ll walk the kitchen, tell you straight what’s failing and what it costs, and put the full scope in writing before a single tool comes out.
Written by Curtis Lane, Owner, Bradford Remodeling Co Jacksonville, serving Jacksonville and nearby areas.
