Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Owens Corning Kitchen Remodeling: The Jacksonville Owner’s Guide
An Owens Corning kitchen remodel in Jacksonville runs $14,000 to $45,000 installed, depending on the cabinet line, countertop material, and whether you’re moving plumbing or electrical. We stock and install the full Owens Corning-compatible kitchen package: cabinets, quartz and laminate counters, sinks, and hardware, and we can typically begin your project within two to three weeks of a signed scope. Most Jacksonville homeowners discover they’re ready for this when cabinet doors start sagging, drawer slides bind up, or the laminate on a counter edge has peeled back far enough that a sponge catches on it every time you wipe down.
Key Takeaways
- Full Owens Corning kitchen remodels in Jacksonville run $14,000 – $45,000; smaller scopes start around $9,000.
- We install Owens Corning cabinetry and surfaces with a written price before any work starts.
- The 365-Day Done Right Promise covers every finished kitchen in writing for a full year.
- Curtis Lane and his crew have remodeled kitchens across Jacksonville, from Riverside to the beaches.
Which Owens Corning Models This Applies To
Owens Corning’s kitchen line spans three cabinet series that show up most often in Jacksonville homes: the builder-grade Foundations line, the mid-tier Classic series, and the full-overlay Reserve collection. The gotcha we see on job sites is that Foundations and Classic share a door profile but not a hinge spec, so a homeowner who orders a replacement door by look alone ends up with hardware that doesn’t seat. Check the inside of a cabinet box for a white label with the series name and a four-digit production code. That code tells us the exact door style, finish, and bore pattern without guessing.
For countertops, Owens Corning’s laminate and quartz lines each have their own edge profiles and thickness tolerances: laminate runs 3/4-inch with a rolled or square edge, while the quartz tops are 3cm with either an eased or pencil edge. Aftermarket laminate sheets will fit an Owens Corning counter, but the color match on a partial replacement is almost never exact. We pull from Owens Corning’s current color deck unless a discontinued color is confirmed by that production code, in which case we have Jacksonville fabricators who can match discontinued laminate within a commercially acceptable tolerance. Bradford Remodeling Co Jacksonville is an independent contractor, not affiliated with Owens Corning, but we work from their spec sheets and order directly through their distribution network.
Styles & brands we work with
Signs Your Owens Corning Kitchen Remodeling Is Failing
- Drawer slides binding or popping out of the track. The nylon rollers wear flat over 10 to 15 years of use. Once one side degrades, the drawer cocks and starts eating the slide rail itself.
- Door hinges loosening at the frame. Owens Corning cabinet boxes are particleboard with a solid wood face frame. The hinge screws strip out of the particleboard when a door has been over-shimmed or slammed repeatedly.
- Laminate peeling at the sink edge or dishwasher return. Water exposure hits the substrate at the miter seam first. In Jacksonville’s humidity, that edge swells and the laminate bond fails from the corner inward.
- Cabinet boxes sagging off the wall. We see this in older Jacksonville kitchens where the original installer hung the uppers with drywall screws instead of cabinet-grade fasteners into studs, or where a hidden leak softened the back panel.
- Countertop seams opening up. Quartz seams are filled and polished, but if the substrate shifts, the seam opens and catches crumbs and water. Laminate seams fail at the miter after years of heat from a dishwasher or a slow drip at the faucet base.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Jacksonville, a full Owens Corning kitchen with the Classic cabinet line, a quartz counter, new sink and faucet, and standard backsplash lands between $14,000 and $45,000 installed. A small galley or condo kitchen with the Foundations line and a laminate top runs $9,000 to $20,000. Here’s how the pieces break down:
| Scope | Jacksonville Price Range |
|---|---|
| Full kitchen remodel (Owens Corning cabinets, quartz, fixtures) | $14,000 – $45,000 |
| Small kitchen remodel | $9,000 – $20,000 |
| Cabinet installation only (Owens Corning) | $4,000 – $13,000 |
| Countertop installation only | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
The spread depends on cabinet series, linear feet of counter, whether you’re moving the sink or gas line, and what we find under the old cabinets when they come out. Every number above is a written line-item price before we start. No change orders at the door, no reprice when the crew shows up. The 365-Day Done Right Promise covers every installation: if a hinge, slide, seam, or any part of the work fails within the first year, we come back and correct it at no charge. That’s in writing, signed, in your hand at closeout.
DIY or Call Us?
You can safely handle the diagnosis: open every drawer, check for binding, look under the sink for swelling, run your hand along counter seams to feel for lifting, and check cabinet tops for sag. Replacing a drawer slide or tightening hinge screws is a weekend job if you have the right driver bit and some patience. Cabinet removal and countertop replacement are not. The danger zone is when an upper cabinet has pulled from the wall, or when the countertop is load-bearing for the sink and faucet. Cabinets can drop hard when they let go, and a full upper with dishes weighs more than most people expect. Disconnecting a sink, pulling a gas range, and rehanging boxes straight on a wall that’s been out of plumb for twenty years is work you want a crew doing daily, not something you learn from a video. If you’re not sure which side of the line you’re on, call (904) 337-5929 and we’ll tell you straight over the phone.
FAQs
Figure 15 to 25 years for the cabinet boxes and face frames in Jacksonville’s humidity, with hinges and drawer slides wearing out at the 10 to 15 year mark. The boxes fail early when a roof or pipe leak soaks the particleboard; the hardware fails from normal wear. We’ve remodeled Jacksonville kitchens where the boxes were fine at 30 years and only the slides and hinges needed attention, but those are kitchens that never saw a leak.
Often, yes. Stripped hinge screws can be plugged and redrilled with new screws, drawer slides can be swapped for fresh hardware, and a sagging upper can be remounted properly if the box itself hasn’t rotted. The line where repair stops making sense is when the substrate is water-damaged or the face frame joints have separated. Call (904) 337-5929 for an exact assessment; we’ll give you a repair price and a replacement price side by side, and let you pick.
A full kitchen gut-to-finish runs four to eight weeks, depending on whether plumbing or electrical moves, how long counter fabrication takes, and what inspection schedules look like in Jacksonville that month. A cabinet-and-counter swap with no plumbing moves can be done in two to three weeks. We give you a written schedule with milestone dates before work starts. If we miss a milestone, you’ll know why before the end of the same business day.
We stock common replacement hardware on the truck: Owens Corning-compatible hinges, drawer slides, and mounting fasteners, plus touch-up and seam fill for laminate and quartz. Cabinet doors, full boxes, and counter slabs are ordered per project from Owens Corning’s distribution network with your production code verified before we place the order. For a sudden failure, we can often get moving the same week with what’s on hand and the right part on order behind it. Call (904) 337-5929 and we’ll confirm what’s available for your exact series.
Scope it right the first time: the job goes a lot smoother when nobody’s surprised. That’s how Curtis Lane runs every Owens Corning kitchen remodel in Jacksonville, and it’s why we put the full price, the schedule, and the guarantee in writing before the first cabinet comes off the wall. If you’re ready to price an Owens Corning kitchen remodel in Jacksonville, call (904) 337-5929 for a free estimate with no numbers that move at the door.
Written by Curtis Lane, Owner, Bradford Remodeling Co Jacksonville at Bradford Remodeling Co Jacksonville, serving Jacksonville and nearby areas.
