Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
See the difference
Before
After
Before
After
Before
AfterHow Much Does Metal Roof Installation Cost in Jacksonville?
Metal roof installation in Jacksonville typically runs between $15,000 and $40,000 for a standard single-family home. The average homeowner in Duval County pays around $24,000 for a standing seam metal roof on a 1,800-square-foot house. That figure includes materials, labor, tear-off of the existing roof, and basic underlayment, but the spread between the low and high end comes down to the metal type, roof complexity, and whether you’re paying for a full tear-off or an overlay.
We’ll break down what drives those numbers so you can look at a written estimate and know whether it’s fair. No vague “it depends” without a number attached. You’ll know the cost per square foot, the line items, and what Jacksonville’s climate does to metal roofing prices that a generic national article won’t tell you.
Metal Roof Installation Cost Breakdown (2026)
Here’s the line-item reality for Jacksonville, based on what we see on bids across Arlington, Mandarin, Riverside, San Marco, and the beaches. The numbers are presented as installed costs, including labor.
| Line Item | Cost Range (Installed) | Notes |
|---|---|---|
| Tear-off and disposal of existing roof | $1,800 – $4,500 | Single layer vs. multiple layers. Jacksonville code requires full tear-off when two or more layers exist. |
| Metal panels (standing seam, galvalume) | $9,000 – $22,000 | Runs $9 – $16 per square foot installed depending on gauge and finish. |
| Metal panels (exposed fastener / corrugated) | $7,000 – $15,000 | Cheaper per square foot, but higher maintenance over 20 years in coastal air. |
| Underlayment (synthetic or high-temp peel-and-stick) | $1,200 – $3,000 | High-temp rated is mandatory under metal in Florida’s heat. Some cheap bids skip this. Don’t let them. |
| Flashing, trim, ridge caps, and closures | $2,000 – $5,500 | Where leaks happen. The roofer’s attention here separates a 30-year roof from a 10-year one. |
| Fastener system (clips vs. exposed screws) | $800 – $2,800 | Standing seam with concealed clips costs more up front, lasts far longer in hurricane wind uplift. |
| Labor | $4,500 – $10,000 | Jacksonville labor rates for experienced metal crews run $250 – $450 per square (100 sq ft). |
| Permits and inspections | $300 – $800 | City of Jacksonville building permit and wind-load inspection. |
| Total (typical full install) | $15,000 – $40,000 | The range in the quick answer above. |
What moves you toward the $40,000 end? A steep-pitch roof on a two-story house in Ortega with multiple valleys, dormers, and a high-wind zone (anything east of the Intracoastal). What keeps you at $15,000? A simple gable roof on a single-story house in a neighborhood like Oceanway or Cedar Hills with a shallow pitch and straightforward access.
One more Jacksonville-specific point: hurricane wind-load requirements. Florida Building Code Section 1609 mandates uplift resistance for metal roofing in our wind zone. That means more clips, more fasteners, and a specific installation pattern. A roofer quoting below $15,000 for a full standing seam install in Jacksonville is almost certainly cutting corners on the fastener schedule. Ask for the wind-load calculation in writing. We put it in every proposal.
What Affects Metal Roof Installation Pricing in Jacksonville
- Distance from the Atlantic. Homes east of US-1 (the Beaches, Ponte Vedra area, parts of Arlington) sit in a higher wind zone. Fastener requirements increase, and so does the per-square-foot cost. A roof in Neptune Beach can cost 10 – 15 percent more than the same house in Murray Hill, strictly due to code requirements.
- Roof pitch and complexity. Jacksonville’s older neighborhoods (Riverside, Avondale, Springfield) are full of steep-pitched roofs with multiple gables and valleys. That’s more metal, more cutting, more flashing, and more labor hours. A flat or low-slope roof in newer subdivisions costs less to cover but may need different panel profiles.
- Metal type and gauge. 24-gauge galvalume is the most common. 22-gauge costs more but performs better against hail and wind-driven debris. Aluminum runs about 15 – 20 percent above steel but resists corrosion in salt air. Copper is a completely different animal, often $20 – $30 per square foot installed, and rarely justified except on a historic home in Riverside or San Marco.
- Existing roof condition and layering. Jacksonville’s humidity creates a hidden problem: when an asphalt shingle roof fails, the decking beneath it is often damp or soft from years of trapped moisture. If your roofer finds rotted plywood during tear-off, expect $1.50 – $2.50 per square foot to replace the affected sections. That’s a legitimate change item, but it should only be paid after you’ve seen the damage.
- Season and contractor availability. Jacksonville’s roof replacement window runs October through May, before summer storms and afternoon lightning. Metal crews book 4 – 8 weeks out in that window. Pricing is firmer then. During hurricane season, you’ll find more availability but you’ll also find more out-of-state crews chasing storm work. That’s a risk we’d rather you not take.
- Standing seam vs. exposed fastener. Exposed fastener metal roofs (the corrugated ag-panel look) run $7 – $11 per square foot installed. Standing seam runs $11 – $18 per square foot installed. The difference is the fastener system: concealed clips vs. screws that penetrate the panel. In Jacksonville’s heat, exposed fasteners with rubber grommets break down faster. If you’re planning to stay in the house 15 years or more, the standing seam pays for itself in zero fastener replacement.
How to Save on Metal Roof Installation
The cheapest way to pay for a metal roof in Jacksonville is to pay for it once, correctly. But if you’re looking for real ways to keep the number down without sacrificing the roof, here’s what actually works:
- Time it for the shoulder season. November through February is slower for Jacksonville roofers. You won’t get a dramatic discount, but you’re more likely to have a crew’s full attention and a bid that isn’t padded for weather risk. Call us at (904) 337-5929 for a written estimate any time, and we’ll tell you honestly what the current schedule looks like.
- Choose a simple profile. A single-panel standing seam in a standard gauge, without custom trim or accent panels, costs significantly less than a roof with decorative ridge treatments or mixed metals. The roof performs the same.
- Handle the decking issue early. If you know your roof has soft spots, say so during the estimate. It’s cheaper to plan for decking replacement than to discover it at tear-off and stop the job mid-stream.
- Take the written price seriously. Bradford Remodeling gives you a fixed, written price before any work starts. That’s The Garrison Standard at work: no numbers that move at the door, no “we found something” upcharges that weren’t already discussed and documented. The savings is in not being surprised.
One more way to save: don’t finance through the roofer unless you’ve compared their rate against a home equity line or a credit union. Metal roofing is a big-ticket item, and the difference between 7 percent and 12 percent over ten years is thousands of dollars. The roof is worth it. The lender’s margin is negotiable.
FAQs – Metal Roof Installation Cost
How much does a metal roof cost per square foot in Jacksonville?
Installed metal roofing in Jacksonville runs $12 – $22 per square foot for standing seam, and $8 – $13 per square foot for exposed fastener panels. The per-square-foot number includes all materials, labor, underlayment, and fasteners. For a precise number on your roof, call (904) 337-5929 and we’ll measure it for free.
Is a metal roof cheaper than shingles in the long run?
No, a metal roof costs more up front. A shingle roof in Jacksonville runs $8,000 – $20,000, while metal starts around $15,000. But metal typically lasts 40 – 60 years with minimal maintenance, versus 15 – 20 years for asphalt shingles in Florida’s heat and humidity. Over 40 years you’d pay for two or three shingle roofs. Metal wins on lifetime cost, not first cost. The math only works if you plan to stay in the house.
Does metal roofing lower my insurance premium in Florida?
Often, yes. Many Florida carriers offer discounts for metal roofs with a current wind mitigation inspection, particularly for roofs with a Miami-Dade or Florida Product Approval number. The discount varies by carrier and policy, typically 15 – 35 percent on the wind portion of the premium. Ask your agent about the wind mitigation credit before you sign the roof contract. Some carriers in Florida require a roof replacement anyway before they’ll write a policy on an older home.
Can I install a metal roof over my existing shingles in Jacksonville?
In most Jacksonville situations, no. City code and manufacturer warranties typically require a full tear-off to inspect the decking. An overlay hides rot, adds weight, and traps moisture in a climate that already has too much of it. Some exposed fastener systems can be retrofitted over a single layer of shingles with a batten system, but we don’t recommend it. The warranty gets murky and the decking never gets checked.
How long does a metal roof installation take in Jacksonville?
A standard single-family home in Jacksonville takes 3 – 7 working days for tear-off and metal installation, depending on size and roof complexity. Weather is the wild card from June through September, when afternoon thunderstorms can stop work. A written schedule with a weather clause is part of the written proposal at Bradford Remodeling. You’ll know the plan before the crew arrives.
Are metal roofs noisy when it rains?
No, not when installed over a solid deck with proper underlayment. The myth comes from old barns with exposed rafters and no decking. A residential metal roof in Jacksonville sits over plywood decking and an insulated attic. You won’t hear rain any more than you would with asphalt shingles. If a salesperson tells you otherwise, find another salesperson.
Why Jacksonville Homeowners Choose Bradford Remodeling for Metal Roof Installation
We’re not a roofing company that happens to do remodels. We’re a remodeling contractor that runs by a written standard. Every metal roof installation begins the same way: a measured roof, a written line-item estimate, and a signed agreement that locks the price. That’s The Garrison Standard, part of the Garrison Partners family since 2004. Our Jacksonville operation is independently owned and operated, but we’re held to the same standard as every other Garrison location.
Here’s what that means in practice:
- The 365-Day Done Right Promise. Every completed roof carries a full-year written guarantee. If the work fails inside that window, Bradford comes back and corrects it at no charge. Not a pro-rated warranty. Not a “we’ll get to it.” A written promise with a deadline.
- Written price before any work starts. You’ll see the line items, the material brands, the fastener schedule, and the permit costs before you sign. No numbers that move at the door.
- Background-checked, uniformed technicians. You’ll know who is on your roof. Our crews arrive in marked vehicles, with identification you can verify. The conduct standard is set at the Garrison Partners level, not left to whoever shows up.
- A live person answers the phone, 24/7. Not a call center. Not a voicemail box. A real person at our Jacksonville office picks up, day or night. If a storm blows a panel loose at 2 a.m., you’ll talk to a human.
- Documented materials. We install panels and components from manufacturers with published specifications and transferable warranties. The material list goes into your file. You’ll know what’s on your roof, in writing.
Curtis Lane leads our Jacksonville team. He signs the written price alongside you, and he’s the one who answers when the 365-Day guarantee is invoked. That’s the point of the whole system: one accountable person, not a rotating cast of subcontractors.
Our home page has the full scope of what we do. If you’re specifically looking at a metal roof, the detailed page on Metal Roof Installation in Jacksonville covers materials, the process, and what to look for in a roofer’s wind-load documentation.
Get a Written Metal Roof Estimate in Jacksonville
If you’re tired of bids that are more guesswork than commitment, call Bradford Remodeling Co Jacksonville at (904) 337-5929. We’ll measure your roof, walk you through the metal options that make sense for your house and your wind zone, and hand you a written price. No pressure. No countdown. Just the number in writing, backed by the 365-Day Done Right Promise.
A metal roof in Jacksonville is a 40-year decision. You should see the math before you sign anything, and the person who signs the estimate should be the one who stands behind it. That’s the way we’ve done it since 2004.
Pricing reflects the Jacksonville market as of 2026. Bradford Remodeling Co Jacksonville offers free estimates – call (904) 337-5929.
Written by Curtis Lane, Owner at Bradford Remodeling Co Jacksonville, serving Jacksonville since 2004.
What Our Customers Say
"Home remodel with a new floor plan. Handled structural work and permits without drama."
- Gus R."Painting and drywall repair were flawless. They patched the drywall seams and the paint matches the old wall."
- Cal P."Replaced old windows and trim while redoing the kitchen. Clean finish work."
- Ron F.
